December Paper Pad Club: Gift Card Holder Tutorial

Quick & Easy DIY Gift Card Holder Tutorial

Looking for a fast and adorable way to dress up a gift card? This sweet little holder is the perfect solution for birthdays, holidays, or "just because" moments.

Measurements & Materials

• Base Panel: 8.5 x 3.5” (You can get three of these from a single 8.5 x 11” sheet!).

• Belly Band: Use the remaining 0.5” strip from your cardstock sheet.

• Patterned Paper Layers: I used the Love & Kisses Paper Pad.

  • Front Flap: 3.25 x 2.25”.

  • Front Pocket: 3.25 x 1.75”.

  • Inside Flap: 3.25 x 2.25” (I recommend white cardstock for a clean look).

  • Inside Pocket: 3.25 x 3.75”.

Step-by-Step Instructions

1. Score & Fold: On the 8.5” side, score at 2.5”, flip the paper 180 degrees, and score at 2”. Fold both lines inward; the shorter side will become your pocket, resulting in a 4 x 3.5” card.

2. Directional Check: Be sure to choose your directional paper based on whether you want a top-opening or side-opening holder.

3. Assemble the Layers: Adhere your patterned paper layers to the front and inside, leaving the back of the card blank.

4. Create the Pocket: If you like, cut a thumb notch on the pocket panel using a circle punch or die Apply a thin line of glue to each of the two short sides of the pocket flap to secure it.

5. Add the Belly Band: Wrap your 0.5” strip around the card with a little "give" so the ends overlap. Secure the ends and trim away any excess. Remember to consider your belly band needing to slide off and on if you decide to place your ephemera where it extends beyond the edge of the card..

The Finishing Touches

Pro-Tip: You can wrap your belly band either vertically or horizontally depending on the look you want to achieve!

Does this look like something you’d like to make? We’d love for you to share your Not 2 Shabby creations in our Facebook group!